Challenge the No 1 of Salt Spray Test

If you are making the salt spray test with +80 ℃ or +85 ℃, What you should do ? Because all the salt spray test chambers factories only promise the temperature range for their salt fog chambers is +20 °C ~ +55 °C. This is a fact and cannot be changed. Because the test container material from salt spray chambers manufacturers are corrosion resistant PVC plate. This material has excellent corrosion resistance during salt spray testing. But the disadvantage of this PVC sheet is that when the temperature is higher than +55 ℃, the PVC sheet begins to soften.

When the sample is tested at a temperature of +80 ℃, it is likely that the shell of the machine will be melted away due to the high temperature. Water flowed out of the test area, causing a lot of standing water on the laboratory floor. If there were other highly sophisticated experimental instruments next to this salt spray chamber, The large amount of water flowing out will damage some of the surrounding experimental equipment. This kind of loss, just think of, will feel very terrible !

stainless steel 316 salt spray test chamber

Model Description #
WEW-YW-90D-85
Inner Dimension(mm)
900*600*500 (W*D*H)
Outer Dimension(mm)
1470*950*1350 (W*D*H)
Temperature Range
+20℃ ~ +85℃
Spray Method
Non crystalline nozzle
Sample Qty: 15 Degree Angle
60 Pieces , 150*70(mm)
Room Temperature Tests
NSS ACSS 35℃±1℃/ CASS 50℃±1℃
Pressure Barrel Temperature
NSS ACSS 47℃±1℃/ CASS 63℃±1℃
Compressed Air Pressure
1.00±0.01kgf/cm2
Heater: Laboratory Power
2.5 KW
Saturation Device
0.5 KW
Water Tank (L)
Plastic Tank 25L

Wewon Environmental Chambers Co., Ltd. has a very good solution that allows you to operate at + 80 ℃ or + 85 ℃, You can still do salt spray tests for a long time. I would say that this design is unique and very rare on the market.

As you can see from the picture of the machine below, This salt spray chamber from Wewon is made of stainless steel 316. Stainless steel 316 material is the advantage of corrosion resistance, Under the condition of +100℃, the 316 SUS material will not have any deformation or damage problems. Yes, stainless steel material, and not afraid of +100 ℃ high temperature, is it ?

Even if the test area can reach the high temperature of +80℃ or +85℃, the control part of the machine and the circuit template, It is not affected by the high temperature in the test area. Therefore, This stainless steel 316 material salt spray test chamber is very good to solve the user in very high temperature conditions, for salt spray test.

stainless steel salt spray chamber's test room

Although this high temperature corrosion resistant test condition, the use of the scope is not very wide. But many laboratories still want it. For example, Many girls when they are getting married, They choose to buy wedding dresses instead of renting them. I believe you can understand this truth !

Wewon Environmental Chambers Co., Ltd. always do their best to meet the customer’s customized needs. If you have similar high-end customization requirements in terms of test performance for a salt spray chamber, You are welcome to contact us. We have a very good technical team, Once we have received your technical requirements, We will give you a reply within 24 hours. Thank you

© Copyright 2014-2018. Wewon Environmental Chambers Co., Ltd.